🧾 Description
This guide explain how you can capture an image over 9600-Series Ethernet interface
🛠️ Resolution Steps
1) Scanner PM9600 must be in Radio High Speed Mode (default)!
High Speed
Low Speed
2) Scanner PM 9600 must be in point to point mode:
$P,CRFPP01,P\r
Example:
How to do exactly:
Image transfer uses a dedicated socket port 53000.
To start an image download session, a specific command has to be sent on the data socket port 51000
Supports the image format supported by the product (JPG, RAW and BMP)
Image download commands are the same already used on the HHS 2D readers in USB COM:
x018000000000 (capture on trigger)
x008000000000 (capture immediately)
If you are using a mobile product, you have to set a point to point connection to receive the image.
Supported by all models: D/M/BT
How to test:
Open 2 Hercules sessions. One on port 51000, the other on port 53000.
On port 53000, enable the log (right click of the mouse on the data window and create new file).
On port 51000, send the image acquisition command x00800000000[CR] to start the image acquisition process.
After sending the command on port 51000, you can see the data flowing on port 53000.
When all the data has received, close the log session on port 53000.
Scanner supports different image formats of JPG and BMP. Verify and note the scanner's image capture format configuration.
- Saving the log file, give the file a name and apply the correct file extension .jpg or .BMP. This is based on the scanner's image capture configuration.
Note:
Download my not be as fast as you would think (300kb jpg download is around 30seconds).
We suggest to reducing the image quality factor to make the image file smaller for a faster download.