🧾 Description
This feature inside Advanced Formatting is destinated to the customers that need to replace characters but mainly in a specific code family like the example below. On the contrary, Character Conversion parameter (Data Format) is applied to any code read.
🛠️ Resolution Steps
First step is to Enable the general Advanced Formatting and to select the No Match Result of the rules you are going to apply:
Clear data: if the rule will not match, no codes will be transmitted.
Transmit data using standard format: if the rule will not match, codes will be transmitted without any changes
2 .Enable Format 1 and set the Match Code Conditions like Code Type, Code Length, etc. By default, it will be applied to any code:
Or if you know that codes will always be from the same family, will always have same length and some fixed characters like in the next example:
3. Go to Character Replacement to enable it and select the Character to Replace and the Character Replaced:
4. To get it work it is necessary to define 1 Field as Last Field:
5. Finally it is possible to Apply the standard formatting after the replacement (global prefix and suffix) or not
6. To get your configuration codes click on the three top lines and then Export Configuration: