🧾 Description
Below is a guide on setting up a slave in a STS environment.
🛠️ Resolution Steps
Please make sure the camera you are replacing is the same type of ATS400.
You will need to log in to the replacement camera and set the slave address to match the original.
You may also need to change the acquisition trigger and code search priority if it is not the same odd or even slave address as the original.
Slave Reader Configuration Notes for Manual Updating:
Same configuration as master except for the following:
READING SYSTEM LAYOUT:
Device Network Setting = Alone o ID-NET
Topology Role = Slave (synchronized)
Slave Address = 1,2,3, …
OPERATING MODES:
Acquisition Trigger Delay for SLAVES 1,3, 5,… (odd nodes)
Status = Enabled
Delay Time (x100us) = 20
Acquisition Trigger Delay for SLAVES 2,4,… (even nodes)
Status = Disabled
1D CODES:
Code search priority =
45 Degrees (odd nodes)
Horizontal/Vertical (even nodes)
NOTE: In addition to the above parameters, the master reader may require
changes to the setup parameters that handle the communications between
the STS400™ and the host computer. Refer to the