🧾 Description
For the PM9100, the minimum firmware is : 610102924
🛠️ Resolution Steps
Example of frame to be transmitted to the reader in Asynchronous mode:
<DC2><ESC>[2JMESSAGE<CR>
or
<DC2><ESC>[2JLOOK SCREEN<ESC>[8q<ESC>[2q<CR>
(this makes a long beep and turns on the red LED)
or
<DC2><ESC>[2J<ESC>[3q<ESC>[0q<ESC>[9q<ESC>[6qHello Reader 1<CR>
(this makes a short beep and turns on the green LED)
These sequences can be sent at any time via the host.
There is no acknowledgement requested either from the host or from the gun, because in this case it is a synchronous protocol (2way).
Point to point method: 1 reader on 1 base
If the reader is already linked to the base station:
Restore « USA default » :
Scan one of the following interfaces (only 1 choice possible depends which protocol needed):
Now it is possible to address the message to the only gun connected.
Via MicroRidge (RS232 or USB-COM) @115200 :
Sequence: \x12\x1b[2JMESSAGE\x0d
Via Genius (RS232, USB-COM or Ethernet):
Create a Macro with this sequence: <DC2><ESC>[2JMESSAGE<CR>