🧾 Description
Explanation for getting LOG´s from base BC9180 ETH by using DL Aladdin SW
🛠️ Resolution Steps
With PC and BC9180 ETH base connected to the same network, start DL Aladdin. You may directly find the base or it may be necessary to search for it through the “Device Autodetection”/”Search On Connection” option:
Next browser will be open where, after a few seconds, the IP address of the base will appear at the bottom, click Search On Connection:
Click on image of the device to access to the configuration:
When inside the base configuration, go to "Terminal" tab and place the cursor on the upper window "Send" to later send the necessary commands that will make us get the records or LOG's of the base. The LOG box can be checked or not, it´s only to see the commands sent to base:
Commands to send are the following:
$L01
$L02
$L03
$L04
$L05
$L06
$L07
$L08
$L09
$L0A
To send them, write one and press the “Send” button, then next command and so on. The base will return a string of information in the lower window when receiving the command. First empty information string we receive will indicate that there are no more registered values, therefore, it will not be necessary to send more.
Click on the “Save Text” button to save the registered values of the base. To reset the records or LOG´s, send the command $AR and, if we do not need to make any changes in Aladdin, disconnect the device with the icon intended for this purpose.