🧾 Description
This guide is for setting up a master/slave system using DL.Code.
🛠️ Resolution Steps
Open DL.Code and connect to the master camera. Please make sure the slave device(s) are connected via physical ID net connection (QL 100/150s or CBX boxes).
Click the Setup Internal Network Configuration button in the middle. If this button is greyed out click Options>Change User and set yourself as an Installer-Expert:
Verify your slave devices are shown under your master devices. If they are not shown you can right click to add a device as a place holder and/or you may need to recheck your cables and try again.
To have all of the devices use the masters trigger you will want to click Set Default Synchronized Phase mode Configuration. If each device is using their own triggers click Set Default Multidata Configuration.
When saving configs on to a Master/Slave setup it is recommended to save changes to the slaves as well.
Note: Cloning is not recommended as it will copy the focus values of the master to the slave.